brazerzkidaibrands.blogg.se - Vinylstudio dsd noise

VINYLSTUDIO DSD NOISE PRO
VINYLSTUDIO DSD NOISE PROFESSIONAL

VINYLSTUDIO DSD NOISE PRO

"DSD recording capabilty" of the ADI2 Pro means that it outputs an "analog DSD-Quality-Signal", not a digital one. The "best possible digital connection" between the ADI2 Pro and the Tascam is a 192 KHz / 24 Bit via the AES output or the SPDIF coax provided with the BO968 (the DA300 could accept 192/32 Bit as max. My "dream" is to avoid that DA-AD step for the recording device.Īlso confused about the "BO968 breakout connector", it gives AES/EBU Input/Output and SPDIF coaxial Input/Output to the DIGI96/8 PRO which is no longer in Production (?) - maximum digital Input configuration for this card is 96/24. It follows, that my DA 3000 must do another AD-conversion for the analog Input - which it is capable of of course. This looks as if the ADI2 Pro can give DSD recording output "only" as an analog signal, meaning "in the last step" there is a DA-conversion to the output signal. The DSD-derived 176.4k transfer was a close second to the DSD transfer. The pace, rhythm and timing of the DSD transfer was better than the LP. Overall clarity and detail were very good.

Single Wire Mode, Samplefrequenz 28 kHz bis 200 kHz The DSD transfer of 'If Youre In Need' convincingly conveyed Lenny Williams famous gospel-tinged wailing vibrato and came close to the LP.

VINYLSTUDIO DSD NOISE PROFESSIONAL

Format Professional nach AES3-1992 Amendment 4.

1 x XLR, trafosymmetriert, galvanisch getrennt, nach AES3-1992.

The digital output modes for the ADI2 pro as listed online (in German): Generally I found very little info on the DSD "recording" possibilities of the ADI2 Pro in general. Otherwise the Tascam can record every analog input to DSD 2.8 or 5.6 - no problem. Clockfrequency: 44,1 kHz (at 2,8 MHz or 5,6 MHz) I do own a Tascam DA3000 solid state recorder - would love to use the digital DSD -Inputs- of that machine, after the ADI2 Pro. now it gets serious, and here is my main question: 20 Hz-20 kHz at 0.1 THD, both channels driven) 2. 2.828 V out in 4 ohms) Continuous output power into 4 and 8 ohms: 40 W (ref.

Signal-to-Noise Ratio: >98 dB (A-weighted, 500 mV input, ref. but no showstopper.ģ) Adjustable highpass filter for analog Input || Check ?Ĥ) Equalizer stage (channel separated.) > do what I like to the signal or do nothing at all || Check I thinkĥ) Digital output vs. NAD D 3020 v2 Hybrid Digital Integrated Amplifier.

The functionality I am -really- looking for (in a perfect world) is this:ġ) 2 ch Analog Source via XLR > ADI Pro 2 analog In || CheckĢ) Separate channel Input level Control for L / R || ? Not sure. Should serve me as the Pre-Pre-Interface for recording + decent Headphone Amp + USB connector. I am strongly interested in the ADI2 Pro - looks like a dream came true.

Since there is no extra sub-forum for ADDA converters - I hope I'm right in this section. Glad I found this forum - have a sort of "long" question.